Thingiverse
Tiger Tooth
by DioKafaloh
45
Downloads
34
Likes
0
Makes
It is a typical keychain model of a Big and classic saber toothed tiger's tooth.
I recommend to print it at 10 microns,100% infill density, 30 mm/s. Supports don't really matter, once you're done you have to sand it with gradually thinner sand paper (try to get the highest quality as possible), I highly recommend to put some turns of copper on the bottom of the buttonhole.
I recommend to print it at 10 microns,100% infill density, 30 mm/s. Supports don't really matter, once you're done you have to sand it with gradually thinner sand paper (try to get the highest quality as possible), I highly recommend to put some turns of copper on the bottom of the buttonhole.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in