Bud Spencer Bust - No Support Cut

The model is split into segment to print it without support.
It is increased to a height of 130mm total.
The sholder are cut back a bit to give it a better print angle of 55°.
To make the lineup for the gluing easier FilaPins are added to each cut.
For that you will need 6 peaces of 1.75mm filament which are 13mm long.
Therefore i do not suggest to scale the model.
Holes for additional FilaPins are added to the base for a pedestal.

Here is my design:
https://www.thingiverse.com/thing:3