Thingiverse
Pi Hat case Top for Dragino LoRa/GPS board
by rlgjr562
16
Downloads
11
Likes
0
Makes
This is a two piece top based on a long line of remixes, the base is from thing 922740 and the top remix is from 1860278.
The top was split into two pieces the middle piece goes around the Dragino LoRa/GPS v1.4 board with two holes for the RF Antenna connectors. The top piece is removeable without powering the piece down or removing the Antenna cable.
4 M3 x 30mm screws are needed
The top was modified in Tinkercad. Edit it online https://www.tinkercad.com/things/2GLv9bFdGVb
The top was split into two pieces the middle piece goes around the Dragino LoRa/GPS v1.4 board with two holes for the RF Antenna connectors. The top piece is removeable without powering the piece down or removing the Antenna cable.
4 M3 x 30mm screws are needed
The top was modified in Tinkercad. Edit it online https://www.tinkercad.com/things/2GLv9bFdGVb
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in