Thingiverse
Geeetech I3 Pro B Y-Axis Clamp for LM8UU
by CS2000
9
Downloads
6
Likes
0
Makes
Base is printed from flexible PLA. Maybe it dampens the the noise from the bearings a little.
The clamp and the Y belt holder are printed from ABS.
The table is 5mm lower compared to the original Geeetech i3 Pro B Acrylic design with the 8mm distance plate and the zip tie. That's why the Belt Holder must also be 5mm shorter.
Holes are M3, distance 10mm and 16mm from center line of bearing.
The clamp and the Y belt holder are printed from ABS.
The table is 5mm lower compared to the original Geeetech i3 Pro B Acrylic design with the 8mm distance plate and the zip tie. That's why the Belt Holder must also be 5mm shorter.
Holes are M3, distance 10mm and 16mm from center line of bearing.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in