Thingiverse
Emodia pod
by THiiron
4
Downloads
7
Likes
0
Makes
This is a canopy for Emodia Racer single bottom frame. It will accommodate 4in1 ESC, FC, VTX and RX in stack and micro camera in front.
For double bottom frame, you'd need 7mm standoffs or spacers. For single bottom frame there is no standoffs needed at all.
In case of other than Unify pro race v2 VTX, print SMA bracket rather than VTX bracket. This gives you holder for SMA connector for stubby antenna without fixed place for VTX. VTX can be mounted on top of stack with ziptie or double si
For double bottom frame, you'd need 7mm standoffs or spacers. For single bottom frame there is no standoffs needed at all.
In case of other than Unify pro race v2 VTX, print SMA bracket rather than VTX bracket. This gives you holder for SMA connector for stubby antenna without fixed place for VTX. VTX can be mounted on top of stack with ziptie or double si
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in