Sucky NOT Blowy AeroTurbine for 380 motors

This Thing is Very Sucky!

https://www.youtube.com/watch?v=wUE98jNK9iQ

for 380 motors.
- shaft is pressfit, and housing is screwed together.
- motor mounting screw length is 5mm, or just superglue it
- motor should be flush, so slight sanding might be required of the Center hole.
- I recommend using PETG due to its low warping.
- Be careful when removing support, the fins are fragile (file temp2).

Update 1/17/19:
1- New hole mounting pattern for motor, corrected to 16mm from center