Thingiverse
Filament sensor and cleaner
by RuuDimental
23
Downloads
25
Likes
1
Makes
Inline filament sensor and cleaner WIP (work in progress)
To avoid cluttering in my enclosure i feed filament from another closet section by ptfe tubes.
Previously i mounted the filament sensor and a separate cleaner near the filament roll but i found it inconvenient to miss the meter of filament when it the sensor triggered and the hassle of feeding so much filament in one tube.
This new setup i can have several tubes ready to go and just swap near the extruder.
This version is m
To avoid cluttering in my enclosure i feed filament from another closet section by ptfe tubes.
Previously i mounted the filament sensor and a separate cleaner near the filament roll but i found it inconvenient to miss the meter of filament when it the sensor triggered and the hassle of feeding so much filament in one tube.
This new setup i can have several tubes ready to go and just swap near the extruder.
This version is m
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in