Thingiverse
Rick and Morty LED Torch Portal Gun Keyring
by Mattitude
41
Downloads
38
Likes
0
Makes
A fun little keyring modelled on Rick's portal gun from the cartoon series Rick and Morty.
3 LEDs are illuminated instantaneously when the button is pressed.
Electronic components needed:
3x 3mm green LEDs
1x 6x6x6mm push button microswitch
1x CR-2032 coin battery holder
1x CR-2032 coin battery
2x small wires
Solder
Soldering the circuit is tricky due to the small size. It's easiest to connect the wires to the microswitch and run them through the holes into the case. Solder the corr
3 LEDs are illuminated instantaneously when the button is pressed.
Electronic components needed:
3x 3mm green LEDs
1x 6x6x6mm push button microswitch
1x CR-2032 coin battery holder
1x CR-2032 coin battery
2x small wires
Solder
Soldering the circuit is tricky due to the small size. It's easiest to connect the wires to the microswitch and run them through the holes into the case. Solder the corr
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in