Thingiverse
RJ-45 connector protective cap
by mikegi
32
Downloads
25
Likes
0
Makes
Own design quickly made in OpenSCAD.
The original intention was that the connector should be retained, but it doesn't The fit is tight enough that it stays on. Might fix up the design a bit if I decide I want to print a few more.
The OpenSCAD file is there to if someone would like to remix.
The original intention was that the connector should be retained, but it doesn't The fit is tight enough that it stays on. Might fix up the design a bit if I decide I want to print a few more.
The OpenSCAD file is there to if someone would like to remix.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in