MPCNC Switch Endstop Mount
by Mr_Dabrudda
21
Downloads
11
Likes
0
Makes
A re-mix of the MPCNC Endstop Mount. Uses two M3 nuts and two M3x7~10 screws to hold the switch on. Comes in 23.5mm and 25mm sizes.
Cut the excess wiring from the bottom of the switch circuit board
Clean the area where the switch mount will sit on the EMT conduit with rubbing alcohol. Put a few drops of E6000 or Goop glue on mating surface of the mount to hold the endpoint mount on the EMT conduit. Zip ties alone won't prevent movement.
Measure the distance from the corner to the sw
Cut the excess wiring from the bottom of the switch circuit board
Clean the area where the switch mount will sit on the EMT conduit with rubbing alcohol. Put a few drops of E6000 or Goop glue on mating surface of the mount to hold the endpoint mount on the EMT conduit. Zip ties alone won't prevent movement.
Measure the distance from the corner to the sw
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in