Thingiverse
Carbon Filter with FAN
by Joakim
5
Downloads
0
Likes
0
Makes
The STL is for a fan with 50 mm between holes.
The filter used is Duratool as this
https://www.farnell.com/datasheets/2702186.pdf
Cut filter to match the slids in for the 4 filter sections.
In Moai four 3 mm holes are drilled in the "middle plate widh hole for vat holder",
it fits just to the right of the Z drive behind the vat.
that matches the fan. Use 3 mm threaded rod.
The fan shall at half te voltage as described - less noise and less wear on filters.
Supplied is also the Ope
The filter used is Duratool as this
https://www.farnell.com/datasheets/2702186.pdf
Cut filter to match the slids in for the 4 filter sections.
In Moai four 3 mm holes are drilled in the "middle plate widh hole for vat holder",
it fits just to the right of the Z drive behind the vat.
that matches the fan. Use 3 mm threaded rod.
The fan shall at half te voltage as described - less noise and less wear on filters.
Supplied is also the Ope
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in