Thingiverse
Anycubic i3 Mega Raspberry Pi Camera Holder
by d_a_b
36
Downloads
15
Likes
0
Makes
This is a Raspberry Pi Camera holder with LED's used with OctoPrint.
LED's are 12v and powered off the printers PSU, I have 3 in mine but should be able to fit 4 in, mine are warm white but the cold white may be better.
Print the main part in PETG only as the LED's get warm and PLA goes soft.
The camera cover can be in PLA
The holder is designed to slip over the frame with no additional fixings required. It also has a slight upward tilt to give the best possible image.
It has a font
LED's are 12v and powered off the printers PSU, I have 3 in mine but should be able to fit 4 in, mine are warm white but the cold white may be better.
Print the main part in PETG only as the LED's get warm and PLA goes soft.
The camera cover can be in PLA
The holder is designed to slip over the frame with no additional fixings required. It also has a slight upward tilt to give the best possible image.
It has a font
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in