Thingiverse
Filament Spool Bearing
by Blende8
3
Downloads
3
Likes
0
Makes
This is a simple, but very effective filament spool bearing. If you use a printer housing, you can combine it with my brackets: https://www.thingiverse.com/thing:3349758
Its recommended to print it with support filling.
Additional you need two metal bearings 20x37x9
https://www.amazon.de/dp/B00SG1QTCS/ref=cm_sw_em_r_mt_dp_U_tqKrCb7JGT964
and an alloy pipe from your local DIY-store with 20mm diameter.
For finish, I have applied insulation tape over the whole cylinder, to avoid a slip from
Its recommended to print it with support filling.
Additional you need two metal bearings 20x37x9
https://www.amazon.de/dp/B00SG1QTCS/ref=cm_sw_em_r_mt_dp_U_tqKrCb7JGT964
and an alloy pipe from your local DIY-store with 20mm diameter.
For finish, I have applied insulation tape over the whole cylinder, to avoid a slip from
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in