Pegboard small shelf bracket

A simple bracket to hold a wooden shelf on a 1/4 inch (north american) pegboard. It is made to hold a board with a slight chamfer on the edge like most lumber. 2 sizes - one for a 1x4 (nominal) and one for a 1x4 cut in half lengthwise. The big one is 87mm deep (84 to the start of the curve) and the small one is just under 42mm.

For better strength I printed it flat with 0.28mm layer height, extra walls and top/bottom layers and 95% infill.

I used the pins from here: https://www.thingive