Thingiverse
FT Super Bee Nacelles
by RotorGator
19
Downloads
8
Likes
0
Makes
FT Super Bee Nacelles.
I was tired of having to cut out more foam for power pods after a crash. Using these, I have no issues except for the occasional bent prop.
This printed fine without supports. Just remove the integrated support prior and glue up.
The mounting holes on the firewall are 19mm apart. Prior to printing, check which side the motor wires will enter the nacelle. Otherwise, you will have to wrap around like the last picture posted. The default has the wires going to th
I was tired of having to cut out more foam for power pods after a crash. Using these, I have no issues except for the occasional bent prop.
This printed fine without supports. Just remove the integrated support prior and glue up.
The mounting holes on the firewall are 19mm apart. Prior to printing, check which side the motor wires will enter the nacelle. Otherwise, you will have to wrap around like the last picture posted. The default has the wires going to th
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in