Thingiverse
35MM Fan Blade Replacement
by Mizunoslove
7
Downloads
7
Likes
0
Makes
A simple fin replacement for the 35 mm fans on Raise3D Printers.
NOTE: There is a rounded off side, this is the side that should be facing the inside of the fan( where the support cage and label is). You can see it in the preview of the model above. This is meant to be a patch job until you can get the fan replaced. You can see it in the preview of the model above.
Print this out, Disassemble the old fan(Might not need to, but that's what I did). Cut the old fins off, add a little glue
NOTE: There is a rounded off side, this is the side that should be facing the inside of the fan( where the support cage and label is). You can see it in the preview of the model above. This is meant to be a patch job until you can get the fan replaced. You can see it in the preview of the model above.
Print this out, Disassemble the old fan(Might not need to, but that's what I did). Cut the old fins off, add a little glue
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in