Thingiverse
5.25" Half Height Bay Gotek Floppy Emulator Bracket
by Tom_DD
44
Downloads
32
Likes
0
Makes
* Added a new version that fits an OLED with a 28mm wide PCB (called 27mm due to typo), default version is 26mm wide as per the OLEDs I have
Final design and taken out of WiP. Have gone with the 2 hole version as it fits better in most cases, just having the one bottom hole meant on some cases it would be recessed to much. Have kept bezel and non-bezel versions.
I've ordered some 1.3" OLEDs and will put a new design up once I've tested those. For now this only works with the 0.96" 128x64 O
Final design and taken out of WiP. Have gone with the 2 hole version as it fits better in most cases, just having the one bottom hole meant on some cases it would be recessed to much. Have kept bezel and non-bezel versions.
I've ordered some 1.3" OLEDs and will put a new design up once I've tested those. For now this only works with the 0.96" 128x64 O
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in