Thingiverse
PC Fan Controller Box 3.5"
by HowardB
1
Downloads
3
Likes
0
Makes
Very good design by Aussie_ben, thanks for sharing it!
I remixed slightly to make a fully enclosed box for my Vantec Nexus Fan Controller - I'm using it for my 40mm fans on the stepper motors, so wanted it enclosed.
Using Sketchup, I literally sliced/copied the one full side of the box, flipped the orientation and attached to the open side of the box. I moved the middle screw holes on each side by 5mm towards the back so the controller front would fit flush.
A bit of a tight fit, but it
I remixed slightly to make a fully enclosed box for my Vantec Nexus Fan Controller - I'm using it for my 40mm fans on the stepper motors, so wanted it enclosed.
Using Sketchup, I literally sliced/copied the one full side of the box, flipped the orientation and attached to the open side of the box. I moved the middle screw holes on each side by 5mm towards the back so the controller front would fit flush.
A bit of a tight fit, but it
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in