Thingiverse
Samsung Galaxy S5 Stand (Honeycomb)
by riag
3
Downloads
4
Likes
0
Makes
Samsung Galaxy S5 Stand with honeycomb design
due to a bit of unemployment, I had some time to redesign my previous stand, which you can find here:
https://www.thingiverse.com/thing:3376737
The main difference is that it looks nicer and takes longer to print (about 3 hours, with my setup).
The angels of the overhangs are printable without support, however, because the parts of the first layers are not connected I had two failed prints. With support for the first 9mm it worked fine.
due to a bit of unemployment, I had some time to redesign my previous stand, which you can find here:
https://www.thingiverse.com/thing:3376737
The main difference is that it looks nicer and takes longer to print (about 3 hours, with my setup).
The angels of the overhangs are printable without support, however, because the parts of the first layers are not connected I had two failed prints. With support for the first 9mm it worked fine.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in