Thingiverse
MK7 Geared Extruder
by krisdaniels
39
Downloads
31
Likes
0
Makes
This is an experimental extruder that uses an MK7 and no bearings or hobbed bolt.
The design is not yet final, however i've been using it for a while now and it's doing a good job so far.
The files include 2 big gears, top M5 has the M5 nut hole on the top of the gear and the bottom M5 has the hole on the bottom, both work fine, but the bottom M5 will give a bit more space between the X motor and the gears.
When using this on a Smartrap, you need to use the long bowden guide found at ht
The design is not yet final, however i've been using it for a while now and it's doing a good job so far.
The files include 2 big gears, top M5 has the M5 nut hole on the top of the gear and the bottom M5 has the hole on the bottom, both work fine, but the bottom M5 will give a bit more space between the X motor and the gears.
When using this on a Smartrap, you need to use the long bowden guide found at ht
Sign in to leave a comment
Sign in