Thingiverse
Redcat Gen 8 License Plate Light
by RedcatRacing
101
Downloads
68
Likes
0
Makes
This is a license plate light housing for the Redcat Gen 8 International Harvester Scout II scale crawler.
Additional hardware needed:
1pc: M2x8mm cap head screw
To install, you will need to drill a 2mm hole through the body in the desired location. Using the M2x8mm cap head screw, first install the printed washer onto the screw. Next, insert the screw through the body from the inside, and thread into the license plate light housing.
#####Redcat parts on Thingiverse are released unde
Additional hardware needed:
1pc: M2x8mm cap head screw
To install, you will need to drill a 2mm hole through the body in the desired location. Using the M2x8mm cap head screw, first install the printed washer onto the screw. Next, insert the screw through the body from the inside, and thread into the license plate light housing.
#####Redcat parts on Thingiverse are released unde
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in