Eachine 1000TVL mount - Peon 230

This is a remix of the Eachine 1000 TVL camera mount for the Peon 230.

I improved it in two ways. There's now a zip tie cutout to hold the camera down. Before I used tape and it didn't work very well. I also enlarged the cutout (made it a full cutout) for the camera wires (much easier to install, and w/o support the old one sagged enough to block the cable connector).

I printed in PETG with no support at about 30% infill. Should be printed standing up -- Fusion 360 exports it sideways.