Thingiverse
Geeetech A10 LED Light Bar
by nordicblue
135
Downloads
62
Likes
2
Makes
UPDATE 2/7/2019:
WARNING: PRINT IN PETG or ABS. PLA started to warp on me. Not sure if it's the heat from the bed or the heat from the LEDs being inside the housing. I am not going to re-print, as I am changing over to a Petsfang and will use the Petsfang LED bar instead to get light from the front. If you print in PETG or ABS, please post a make with your results.
------------------------------------------------------------------------------------------------------
1/30/2019:
This is a
WARNING: PRINT IN PETG or ABS. PLA started to warp on me. Not sure if it's the heat from the bed or the heat from the LEDs being inside the housing. I am not going to re-print, as I am changing over to a Petsfang and will use the Petsfang LED bar instead to get light from the front. If you print in PETG or ABS, please post a make with your results.
------------------------------------------------------------------------------------------------------
1/30/2019:
This is a
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in