Thingiverse
Crossfire Race Antenna Mount
by piscaj
2
Downloads
2
Likes
0
Makes
TBS Crossfire Race Antenna mount.
The antenna mount should be printed with flexable filament, prefereably TPU. The protective cover is a bit longer than the pcb to accommodate the soldered side of the board that is heat shrunk. This way you can slide the whole bit right in. It may take some wiggling to get the antenna in, its a tight fit.
The antenna mount should be printed with flexable filament, prefereably TPU. The protective cover is a bit longer than the pcb to accommodate the soldered side of the board that is heat shrunk. This way you can slide the whole bit right in. It may take some wiggling to get the antenna in, its a tight fit.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in