Thingiverse
Non-Jamming Filament Joiner
by Thekakester
40
Downloads
26
Likes
0
Makes
Joins two 1.75mm bowden tubes together in a way that doesn't cause filament jams.
The magic is NOT in this part, but rather how well the bowden tube is handled!
Use an angled drill bit ([like this](https://drillsandcutters.com/sm42-1-8-x-7-16-cone-pointed-end-carbide-burr-1-8-shank/)) to widen the hole of the bottom (output) bowden tube. If it's not widened, you're leaving room for filament to jam!
See pic for how the angled output bowden tube should look.
Print on the highest quality
The magic is NOT in this part, but rather how well the bowden tube is handled!
Use an angled drill bit ([like this](https://drillsandcutters.com/sm42-1-8-x-7-16-cone-pointed-end-carbide-burr-1-8-shank/)) to widen the hole of the bottom (output) bowden tube. If it's not widened, you're leaving room for filament to jam!
See pic for how the angled output bowden tube should look.
Print on the highest quality
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in