Thingiverse
Rain Gauge Counter
by PiratDuck
130
Downloads
105
Likes
0
Makes
Made a mecanically counting rain gauge with a housing.
It´s collecting 1 mm of rain water until the tiping bucket tips and turns the ratchet wheel with numbers on it.
Can measure up to 38mm of rain until it returns to 0 again.
It´s 120 mm long and 57mm wide.
Check out the rain gauge in action: https://youtu.be/Cj-3QvpIj8E
To this rain gauge you will need to make 4 length of 1.75mm filament pins that you should melt on the end according to the picture with the following measurements:
2x
It´s collecting 1 mm of rain water until the tiping bucket tips and turns the ratchet wheel with numbers on it.
Can measure up to 38mm of rain until it returns to 0 again.
It´s 120 mm long and 57mm wide.
Check out the rain gauge in action: https://youtu.be/Cj-3QvpIj8E
To this rain gauge you will need to make 4 length of 1.75mm filament pins that you should melt on the end according to the picture with the following measurements:
2x
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in