Thingiverse
Y-axis bracket upgrade CR-20 dampener
by matthijst
44
Downloads
20
Likes
1
Makes
Since i wanted to make my printer more quiet i bought a few dampers...
Unfortunatly my CR-20 came with pressed on pully's. Since i didnt have screw on pully's i designed this new bracket to upgrade the existing one.
The bracket places the nema 17 motor about 8mm futher to the right(seen from front) so you wont need a new pully.
The design uploaded was about version 7 or 8 or so so it is firmly tested and operational!
If you have idea's or upgrades, feel free to reply!
Hope you can
Unfortunatly my CR-20 came with pressed on pully's. Since i didnt have screw on pully's i designed this new bracket to upgrade the existing one.
The bracket places the nema 17 motor about 8mm futher to the right(seen from front) so you wont need a new pully.
The design uploaded was about version 7 or 8 or so so it is firmly tested and operational!
If you have idea's or upgrades, feel free to reply!
Hope you can
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in