Thingiverse
2020 Snap-on filament guide - CR-X
by beckbw
55
Downloads
40
Likes
0
Makes
Most filament guides for 2020 rails don't fit the Creality CR-X which has two top endcaps to support the dual Z-screws.
I remixed Keith Corcoran's design to rotate the 2020 clip 90 degrees and then shorten the height of the whole thing to 2.5 cm.
I then horizontally mirrored the whole assembly for the opposite side guide (so both curve backwards).
Application requires a firm snap into place then a slide to the desired height. Because of the snap install, you might need to increase numb
I remixed Keith Corcoran's design to rotate the 2020 clip 90 degrees and then shorten the height of the whole thing to 2.5 cm.
I then horizontally mirrored the whole assembly for the opposite side guide (so both curve backwards).
Application requires a firm snap into place then a slide to the desired height. Because of the snap install, you might need to increase numb
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in