Thingiverse
Single Relay Enclosed Case for Power Cord
by lensfort
25
Downloads
23
Likes
0
Makes
This case was designed to go along with my Octoprint and Plugin for PSU Control (https://github.com/kantlivelong/OctoPrint-PSUControl) to switch the active line on a 240VAC power cord safely.
Other cases were too open and didnt provide a tight cable grip.
It uses the skinny single board (usually blue) relays from china. Usually having a green and red LED and having the contacts terminal very close to the end of the board.
Use M3 6mm screws along with the brass melt in nuts.
I take no
Other cases were too open and didnt provide a tight cable grip.
It uses the skinny single board (usually blue) relays from china. Usually having a green and red LED and having the contacts terminal very close to the end of the board.
Use M3 6mm screws along with the brass melt in nuts.
I take no
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in