Thingiverse
WaFLCopter Race Antenna Mount
by WaFL_FPV
3
Downloads
4
Likes
0
Makes
**Buy The Frame Here: https://store.bicks.us/home/27-waflcopter-race.html**
**Print Settings:**
Make sure to print out of TPU, and with the flat part of mount flush against the bed. No support needed. I'd recommend 2-4 walls, and infill is best at 10% or higher on a 0.4mm nozzle with 0.2mm layer height.
**Compatibility:**
Currently, the design is based around a TBS Antenna Pigtail.
**Print Settings:**
Make sure to print out of TPU, and with the flat part of mount flush against the bed. No support needed. I'd recommend 2-4 walls, and infill is best at 10% or higher on a 0.4mm nozzle with 0.2mm layer height.
**Compatibility:**
Currently, the design is based around a TBS Antenna Pigtail.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in