Thingiverse
Tardis Knob (whole/half)
32
Downloads
28
Likes
0
Makes
This is a remix of a very cool tardis bottle opener.
I really liked the cleanness of the layout. I shrank it to 75% and added a stem with a 3.4mm hole. It should accommodate a standard drywall screw, or pretty much any junk drawer fastener.
Two versions are provided. One is a full 360 degree tardis, the other is sliced in half vertically to have a thinner profile.
The bottle opener does not need supports, but this design will.
Note: if you downloaded this right after it was publis
I really liked the cleanness of the layout. I shrank it to 75% and added a stem with a 3.4mm hole. It should accommodate a standard drywall screw, or pretty much any junk drawer fastener.
Two versions are provided. One is a full 360 degree tardis, the other is sliced in half vertically to have a thinner profile.
The bottle opener does not need supports, but this design will.
Note: if you downloaded this right after it was publis
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in