Thingiverse
Jack Stand Pad for BMW vehicle
by pbarahona
33
Downloads
20
Likes
0
Makes
This is a pad designed to fit into a BMW car's jacking block so that you can lift your car without damaging it. It should be a nice snug fit.
It can be used with regular harbor freight type jack stands with an upwards curved top. The width of the top can be 25mm (1 inch) maximum.
Message me if you need a version with a wider top section or different curvature radius.
Print with at least 60% infill and 4 layers on the outer walls for stability. No supports needed. Just print the part th
It can be used with regular harbor freight type jack stands with an upwards curved top. The width of the top can be 25mm (1 inch) maximum.
Message me if you need a version with a wider top section or different curvature radius.
Print with at least 60% infill and 4 layers on the outer walls for stability. No supports needed. Just print the part th
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in