Thingiverse
poang Mouse Rest
by BETLOG
40
Downloads
40
Likes
0
Makes
- A mouse-rest/pad that uses a single 4-ish mm woodscrew to attach to an ikea poang chair's arm.
- Not sure if 003 will be too big. Currently using 002 and although not perfect (it's 10-20mm too far forwards) I see no need to go bigger or different.
- I WAS using PET to compensate for the refraction of 3dprinted PLA occasionally making the mouse movement weird. However unless you live in a cold climate this will probably be slightly sticky on your hand, and inhibit movement.
- A cut-to
- Not sure if 003 will be too big. Currently using 002 and although not perfect (it's 10-20mm too far forwards) I see no need to go bigger or different.
- I WAS using PET to compensate for the refraction of 3dprinted PLA occasionally making the mouse movement weird. However unless you live in a cold climate this will probably be slightly sticky on your hand, and inhibit movement.
- A cut-to
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in