Thingiverse
Bulb covers for WS2811 led chains (VASE MODE PRINTABLE)
by dragonchaser
79
Downloads
51
Likes
0
Makes
These are bulb covers for WS2811 led chains (12mm base).
They are vase mode printable, just make sure you print the bottom thick enough (for 0.15mm it needs **47 bottom layers** to get a solid base!!!)
**Note:** The largest icosahedron tends to deformations during the print, not sure if this is a problem of my printer or the model.
They are vase mode printable, just make sure you print the bottom thick enough (for 0.15mm it needs **47 bottom layers** to get a solid base!!!)
**Note:** The largest icosahedron tends to deformations during the print, not sure if this is a problem of my printer or the model.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in