Thingiverse
Anycubic i3 Mega Filament Holder
by Choska
15
Downloads
12
Likes
0
Makes
Hello,
I wanted to make my own filament holder with the center of rotation in the center of the spool.
This spool holder inspired me: https://www.thingiverse.com/thing:2582052
I decided to re-model the holder because I wanted to draw it by myself in Fusion360 and I wanted both ends movable so I could move the spool on shaft a bit.
What else you will need:
1) two pieces of 608 bearings
2) 8mm rod - 15cm long.
Tip: The metal rod was grind with sandpaper a bit from both sides (2,5cm) to
I wanted to make my own filament holder with the center of rotation in the center of the spool.
This spool holder inspired me: https://www.thingiverse.com/thing:2582052
I decided to re-model the holder because I wanted to draw it by myself in Fusion360 and I wanted both ends movable so I could move the spool on shaft a bit.
What else you will need:
1) two pieces of 608 bearings
2) 8mm rod - 15cm long.
Tip: The metal rod was grind with sandpaper a bit from both sides (2,5cm) to
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in