Thingiverse
Anet A8 E10 E12 MKS Gen v1.4 board electronics box
by twhite0101
25
Downloads
18
Likes
1
Makes
I needed a box to house my new MKS Gen V1.4 and two MOSFETs.
I liked the design ashdinalrt worked out, but it was too small for my use.
Remix changes:
The overall length of the box is 242mm
Rearranged the connectors to allow better wire management.
Removed the power hole in the side plate, now you print two side plates. Just run your power wires through any of the hexagon holes.
Removed the hexagon holes in the top plate, this helps push the air through the box instead of some of the
I liked the design ashdinalrt worked out, but it was too small for my use.
Remix changes:
The overall length of the box is 242mm
Rearranged the connectors to allow better wire management.
Removed the power hole in the side plate, now you print two side plates. Just run your power wires through any of the hexagon holes.
Removed the hexagon holes in the top plate, this helps push the air through the box instead of some of the
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in