Thingiverse
100mm -10 degree Bicycle Stem
by karlzhao314
31
Downloads
28
Likes
0
Makes
School "project". Basically just putting this up as proof of ownership.
As title states, this is a 3D printed bicycle stem, measuring 100mm C-C with a -10 degree drop. Steerer clamp is 28.6mm (1.125"), bar clamp is 31.8mm. I don't like positive stems on any bike so I didn't design it to be reversible. There's a separate "Bottom Shim" piece that needs to be glued on that lets the steerer stack be flat.
It uses M5 hardware all around.
PLEASE DON'T ACTUALLY USE THIS!!!!! While it's design
As title states, this is a 3D printed bicycle stem, measuring 100mm C-C with a -10 degree drop. Steerer clamp is 28.6mm (1.125"), bar clamp is 31.8mm. I don't like positive stems on any bike so I didn't design it to be reversible. There's a separate "Bottom Shim" piece that needs to be glued on that lets the steerer stack be flat.
It uses M5 hardware all around.
PLEASE DON'T ACTUALLY USE THIS!!!!! While it's design
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in