3mm PTFE Tube Dry Box Connector

Remix to support 2.85/3 mm filament. Takes 1/4" OD 3mm ID PTFE tubing common on things like Ultimaker. Almost certainly will work with 6mm PTFE tubing as well, as that is very close to 1/4".

It takes a very slight turn on the cap to tighten down (should really adjust that but meh).

This is a finicky print for sizing. It is set for my Ultimaker in ABS, so lots of room left for shrinkage. On some other printers, it might print a little looser, but still should fit fine. I think :)

Many