Thingiverse
Using the Anet LCD (LCD12864) on a MKS Gen 1.4, 1.3 & L
by twhite0101
34
Downloads
19
Likes
0
Makes
This is information on the settings and a small change in the wiring to get them to work together.
The non-requirements are as follows:
No shaving the key off the ribbon cable.
No running wires everywhere.
No removing the plug and turning it around.
No giving 1st born to the devil.
I have posted the ritual over on Instructables, you can get to it here.
Gen 1.4 & 1.3 will require the wire swap, but the Gen L will not. I cannot test the Gen 1.3 or the Gen L; I don't have these b
The non-requirements are as follows:
No shaving the key off the ribbon cable.
No running wires everywhere.
No removing the plug and turning it around.
No giving 1st born to the devil.
I have posted the ritual over on Instructables, you can get to it here.
Gen 1.4 & 1.3 will require the wire swap, but the Gen L will not. I cannot test the Gen 1.3 or the Gen L; I don't have these b
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in