Thingiverse
GT-2 belt holder X-axis above
by Far_a_way
3
Downloads
9
Likes
0
Makes
If it's warm and uncomfortable down below,
near the Hotend;
so there is still space to accommodate upstairs
As you can see, this works too. Sample pressure
from PLA is being tested.
Attention is only that the X-axis runs the other way,
so invert!
Otherwise, a fine thing on top.
Use space where which is.
near the Hotend;
so there is still space to accommodate upstairs
As you can see, this works too. Sample pressure
from PLA is being tested.
Attention is only that the X-axis runs the other way,
so invert!
Otherwise, a fine thing on top.
Use space where which is.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in