Thingiverse
Ender 3 MKS and Raspberry Pi Rear Enclosure
by Worelock
62
Downloads
40
Likes
0
Makes
#UPDATE 14/02/2019 - Do Not Print it
I printed the enclosure over the last couple of days, whilst it all bolted together nicely it doesnt fit in the rear of the frame :(
The drama is the stepper motor and end stop. I will print a modified end stop and see if I can get it to fit before I make some serious changes to the design.
This is a mash up of ideas from many different ideas.
I wanted an enclosure that was mounted at the rear of the printer that would house the MKS Gen L motherboard,
I printed the enclosure over the last couple of days, whilst it all bolted together nicely it doesnt fit in the rear of the frame :(
The drama is the stepper motor and end stop. I will print a modified end stop and see if I can get it to fit before I make some serious changes to the design.
This is a mash up of ideas from many different ideas.
I wanted an enclosure that was mounted at the rear of the printer that would house the MKS Gen L motherboard,
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in