Thingiverse
CR10 Z Crash Pads
by Prestonf
40
Downloads
22
Likes
0
Makes
Crash pads to prevent your printer from crashing the nozzle into your print bed. In the event of a runaway G code, firmware glitch or malfunctioning Z-probe/limit switch these will stop the Z from crashing the nozzle into your print bed. The motors will stall out giving you time to shut the printer down.
To install:
You will need two M3x10 socket head cap screws and two M3 hammerhead T-nuts.
Set your Z to the lowest height you plan to use then install the crash pads to the frame and agai
To install:
You will need two M3x10 socket head cap screws and two M3 hammerhead T-nuts.
Set your Z to the lowest height you plan to use then install the crash pads to the frame and agai
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in