Thingiverse
RC Benchy (ebay friendly)
by lokthelok
76
Downloads
53
Likes
0
Makes
Remixed to fit an eBay jet boat module. Fits like a glove! See image for the type of jet that fits.
Boat prints in multiple parts that need gluing together (watertight). I found that epoxy glue worked well.
A stand model for the boat is included. This is assembled with M3 bolts into tapped plastic.
The rear ESC mount sits on the port side of the boat at the rear to hold the ESC. The rooster tail part was printed is flexible filament to direct the water away from the boat.
The two cli
Boat prints in multiple parts that need gluing together (watertight). I found that epoxy glue worked well.
A stand model for the boat is included. This is assembled with M3 bolts into tapped plastic.
The rear ESC mount sits on the port side of the boat at the rear to hold the ESC. The rooster tail part was printed is flexible filament to direct the water away from the boat.
The two cli
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in