Thingiverse
Bend protection
by GaryK47
27
Downloads
19
Likes
0
Makes
Hi!
I had designed the cable bushing as a bend protection. So that the cables cannot be trapped.
The holder fits a 3030 profile.
PETG should be used as filament because it is quite tough and does not break.
If you have a good printer you can print the spiral without support.
Personally I would choose the support because it is really difficult to print from a certain length.
At both ends of the cable, which goes through the cable entry, a disc must be laid before. See the picture with
I had designed the cable bushing as a bend protection. So that the cables cannot be trapped.
The holder fits a 3030 profile.
PETG should be used as filament because it is quite tough and does not break.
If you have a good printer you can print the spiral without support.
Personally I would choose the support because it is really difficult to print from a certain length.
At both ends of the cable, which goes through the cable entry, a disc must be laid before. See the picture with
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in