Thingiverse
FPVLR CP Antenna Washer for Mavic & Spark
3
Downloads
1
Likes
0
Makes
This is a very simple "washer" designed to properly centre and hold the SMA connector into the Mavic Pro and Spark remote controller.
When you want to upgrade your remote antennas, you have to install a standard connector, this is called a SMA connector. These are smaller than the holes that are in the remote for the factory antennas and as such it is left loose. I didn't just like the tension from the nut holding it down so designed this washer to both centre it, and provide a good surface f
When you want to upgrade your remote antennas, you have to install a standard connector, this is called a SMA connector. These are smaller than the holes that are in the remote for the factory antennas and as such it is left loose. I didn't just like the tension from the nut holding it down so designed this washer to both centre it, and provide a good surface f
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in