Thingiverse
Suspended landing gear for RC airplane
by JadeHawkCE3
77
Downloads
65
Likes
0
Makes
Picture shows a slightly different version of the mounting plate, it was originally quite flexible.
Each hole should be drilled out with a 3mm bit before assembly so the joints can move freely. The split pieces scored and combined with superglue, and each joint is connected with a roughly 15mm section of 3mm steel rod. The joints are then capped off by manually extruding plastic into the hole. The wheels are mounted using the same technique, but with a washer on the flat side of the wheel.
Rub
Each hole should be drilled out with a 3mm bit before assembly so the joints can move freely. The split pieces scored and combined with superglue, and each joint is connected with a roughly 15mm section of 3mm steel rod. The joints are then capped off by manually extruding plastic into the hole. The wheels are mounted using the same technique, but with a washer on the flat side of the wheel.
Rub
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in