![CR-10S5 / CR-10S Legs [Screw On Desk] – 3D printable model from Thingiverse](https://wsrv.nl/?url=https%3A%2F%2Fcdn.thingiverse.com%2Frenders%2F9b%2F46%2F23%2Fae%2F0c%2Fcd5dcc53a07d9b03d5cb2e36feeee7e0_display_large.jpg&w=800&h=800&fit=cover&output=webp&q=80)
Thingiverse
CR-10S5 / CR-10S Legs [Screw On Desk]
by ffalcone
58
Downloads
58
Likes
0
Makes
Made these Legs fot my CR-10S 50x50x50cm Printer.
Printed it with .3 layer height and 33% Infill (May work with less)
Used 3mm Screws for attaching the legs onto my Office Desk.
Seems to work fine after 2 weeks of using.
Total height of the Legs: 120mm
Feet Area Size: 55x55 mm
Top Leg Size: 30x30 mm
Radius of the round Holes on Top: 12.5mm
When attaching the Legs onto the table i found that it adds a little bit more stability if every feet is facing in a different direction. (F
Printed it with .3 layer height and 33% Infill (May work with less)
Used 3mm Screws for attaching the legs onto my Office Desk.
Seems to work fine after 2 weeks of using.
Total height of the Legs: 120mm
Feet Area Size: 55x55 mm
Top Leg Size: 30x30 mm
Radius of the round Holes on Top: 12.5mm
When attaching the Legs onto the table i found that it adds a little bit more stability if every feet is facing in a different direction. (F
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in