IKEA LACK Setup By Monberg75

I made this setup for my Ender 3 printer, as I was limited on space.

The raisers are 10 cm in height, and fit the legs of the table. On top of the raiser, there is a hole for a 5x5 mm cube magnet, and then i used a roofing nail in middle of the table legs for the upper table. Just to get it a bit more stable. It can be left out without a problem.

You need to print 4 raisers (Ask me, then ill make them for your height and put them in the collection)

You need to print 4 upper corners for