USA Flag Leather Stamp per G-Spec reduced to 3" x 1.65"

This is a USA Flag per G-Specs and reduced to 3" x 1.65". It is a reverse image which can be used to make leather patches.

There are a few things I have learned while stamping leather.
1. Purchase a good quality tooling leather.
2. Make your 3D print with at least a 3mm base and then make the impression image 2mm higher. Remember, it must be reversed (including the depth of the impression).
3. Soak and knead the leather for about 5 min in very warm water.
4. Use two, 1/2" thick steel plat