Thingiverse
Ender 3 (Pro) Raspberry Pi Camera Mount + Angle Kit for Octoprint etc.
by JLIspace
258
Downloads
114
Likes
0
Makes
This is a Remix of the pi camera mount initially created by Bugwhale!
I followed his guide but I was not happy about the cameras point of view. Without this "mod" the camera is not centered and therefore you won't see stuff in the front left corner.
Therefore I designed a angle-arm which attaches nicely to the initial mount and camera case.
The two pieces are held together with a single M3 screw + nut.
For any information about what you'll need for the base mount check out the origin
I followed his guide but I was not happy about the cameras point of view. Without this "mod" the camera is not centered and therefore you won't see stuff in the front left corner.
Therefore I designed a angle-arm which attaches nicely to the initial mount and camera case.
The two pieces are held together with a single M3 screw + nut.
For any information about what you'll need for the base mount check out the origin
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in